Table of Contents
Advertisement
Section 5 - Maintenance
Task Interval
Every 200 hours or 3
years
Every 300 hours or 3
years
Every 5 years
Maintenance Log
Record all maintenance performed on your power package here. Be sure to save all work orders and receipts.
Page 48
•
Inspect the U‑joints, the splines, and the bellows. Check the clamps.
•
Check the engine alignment.
•
Lubricate the U‑joint splines and cross bearing, if equipped with grease fittings.
•
Lubricate the gimbal bearing and the engine coupler.
NOTE: Lubricate the engine coupler every 50 hours if operated at idle for prolonged periods of time.
•
Check the engine mounts for tightness and tighten to specifications if necessary.
•
Inspect the condition of the spark plugs, spark plug wires, and the distributor cap and rotor, if
equipped. Replace as necessary. If the condition of these components is satisfactory at
inspection, repeat inspection every 100 hours or once a year, whichever occurs first.
•
Check the electrical system for loose, damaged, or corroded fasteners.
•
Check the cooling system and the exhaust system hose clamps for tightness. Inspect both
systems for damage or leaks.
•
Disassemble and inspect the seawater pump and replace worn components.
•
Clean the seawater section of the closed‑cooling system. Clean, inspect, and test the pressure
cap.
•
Inspect the exhaust system components. If the package was equipped with water shutters
(flapper valves), verify that they are not missing or worn.
•
Replace the coolant/anitifreeze. Replace every two years if not using extended‑life coolant/
antifreeze.
Maintenance to Be Performed
90-8M0057081
MARCH 2011
eng
Advertisement
Table of Contents
