Table of Contents
Advertisement
Section 6 - Storage
Description
Corrosion Guard
Light gray primer
Marine Cloud White paint
(CMD part number: 4918660)
11. Your Cummins MerCruiser Diesel Authorized Repair Facility should now perform all checks, inspections, lubrications, and
fluid changes outlined in Maintenance Schedules.
The universal joint bellows may develop a set when stored in a raised or up position, causing the bellows to fail when returned
to service and allowing water to enter the boat. Store the sterndrive in the full down position.
12. On Sterndrive models, place the sterndrive in the full down (in) position.
13. Follow the battery manufacturer's instructions for storage and store the battery.
Extended Storage Instructions
IMPORTANT: Cummins MerCruiser Diesel strongly recommends that this service be performed by a Cummins MerCruiser Diesel
Authorized Repair Facility.
1.
Read all precautions and perform all procedures found in Preparing Your Power Package for Seasonal or Extended
Storage.
2.
Read all precautions and perform all procedures found in Draining the Seawater System.
3.
Read all precautions and perform all procedures found in Seasonal Storage Instructions.
IMPORTANT: The seawater pump impeller material can be damaged by prolonged exposure to direct sunlight.
4.
Remove the seawater pump impeller and store away from direct sunlight. Refer to a Cummins MerCruiser Diesel Authorized
Repair Facility for additional information and service.
5.
Place a caution tag at the instrument panel and in the engine compartment stating that the seawater pump is out and not to
operate the engine.
Battery
Follow the battery manufacturer's instructions for storage.
Recommissioning
NOTE: Discharge of propylene glycol into the environment may be restricted by law. Contain and dispose of propylene glycol in
accordance with federal, state, and local laws and guidelines.
1.
On engines that were prepared for extended storage, refer to a Cummins MerCruiser Diesel Authorized Repair Facility and
have the seawater pump impeller installed, if it was removed for storage.
2.
On engines that were prepared for cold weather (freezing temperature), seasonal, or extended storage, see Draining the
Seawater System and drain the propylene glycol into a suitable container. Dispose of the propylene glycol in accordance
with federal, state, and local laws and guidelines.
3.
Ensure that all cooling system hoses are in good condition, connected properly, and clamped tightly. Verify that all drain valves
and drain plugs are installed and tight.
4.
Inspect all drive belts.
5.
Perform all lubrication and maintenance specified for completion according to the Annually section of Maintenance
Schedules, except items that were performed at time of engine lay up.
6.
Fill the fuel tanks with fresh diesel fuel. Do not use old fuel. Check the general condition of the fuel lines and inspect the
connections for leaks.
7.
Replace the water‑separating fuel filter or filters (some engines may have more than one).
Disconnecting or connecting the battery cables in the incorrect order can cause injury from electrical shock or can damage the
electrical system. Always disconnect the negative (‑) battery cable first and connect it last.
8.
Install a fully charged battery. Clean the battery cable clamps and terminals. Reconnect the cables. Secure each cable clamp
when connecting. Coat terminals with a battery terminal anti‑corrosion spray to help retard corrosion.
9.
Perform all checks in the Starting Procedure column found in the Operation Chart. See the On the Water section.
Page 116
Where Used
Outside of engine
NOTICE
CAUTION
!
Part Number
92‑802878‑55
92‑802878‑52
Obtain locally
90-8M0057081
MARCH 2011
eng
Advertisement
Table of Contents
