Table of Contents
Advertisement
4.
Ensure that the rubber gasket is inside the gear lube monitor cap and install the cap. Do not overtighten.
a
NOTE: When filling the entire sterndrive, see Changing .
Changing
1.
Remove the gear lube monitor from the bracket.
b
a
2.
Empty the contents into a suitable container.
3.
Install the gear lube monitor in the bracket.
4.
Place the sterndrive in full trim limit out position, remove the gear lube fill and drain screw and sealing washer and drain the
gear lube.
b
a
5.
Remove the gear lube vent screw and sealing washer. Allow the gear lube to drain completely.
b
a
90-8M0057081
MARCH 2011
eng
a -
Gear lube monitor cap
19962
25339
a -
Gear lube fill and drain screw
b -
Sealing washer
7160
7161
a -
Retaining bracket
b -
Gear lube monitor
a -
Gear lube vent screw
b -
Sealing washer
Section 5 - Maintenance
Page 57
Advertisement
Table of Contents
