Every 200 hours or 3
Every 300 hours or 3
Maintenance Log
Record all maintenance performed on your power package here. Be sure to save all work
orders and receipts.
Date
90-860168070 AUGUST 2007
Task Interval
•
Inspect the U‑joints, the splines, and the bellows. Check the clamps.
•
Check the engine alignment.
•
Lubricate the U‑joint splines and cross bearing, if equipped with grease
fittings.
years
•
Lubricate the gimbal bearing and the engine coupler.
NOTE: Lubricate the engine coupler every 50 hours if operated at idle for
prolonged periods of time.
•
Check the engine mounts for tightness and tighten to specifications if
necessary.
•
Check the electrical system for loose, damaged, or corroded fasteners.
•
Check the cooling system and the exhaust system hose clamps for tightness.
Inspect both systems for damage or leaks.
years
•
Disassemble and inspect the seawater pump and replace worn components.
•
Clean the seawater section of the closed‑cooling system. Clean, inspect,
and test the pressure cap.
•
Inspect the exhaust system components. If the package was equipped with
water shutters (flapper valves), verify that they are not missing or worn.
•
Replace the coolant/anitifreeze. Replace every two years if not using
Every 5 years
extended‑life coolant/antifreeze.
Maintenance Performed
Maintenance to Be Performed
Engine Hours
Section 5 - Maintenance
Page 45