Section 5 - Maintenance
3.
Add the specified fluid to bring the fluid level to within the "MIN" and "MAX" lines on the reservoir.
a
a -
Reservoir
b -
"MIN" and "MAX" lines
Tube Ref No.
Power Trim and Steering
114
Fluid
4.
Install the fill cap.
Changing
Power trim fluid does not require changing unless it becomes contaminated with water or debris. Contact your Cummins MerCruiser
Diesel Authorized Repair Facility.
Power‑Assisted Steering Fluid
IMPORTANT: Use only Quicksilver Power Trim and Steering Fluid or Dexron III automatic transmission fluid (ATF) in the
power‑assisted steering system.
IMPORTANT: Running the pump dry will damage the pump. Always check steering fluid levels before operating the boat.
Checking
1.
Center the sterndrive and stop the engine.
2.
Remove the fill cap and dipstick from the fluid reservoir and observe the level.
a.
The proper fluid level with the engine cold should be between the full cold mark and the end of the dipstick.
b.
With the engine at normal operating temperature should be between the full hot and full cold marks.
a
Page 64
b
Description
b
c
d
13064
Where Used
Power trim pump
Typical
a -
Fill cap and dipstick
b -
Full hot mark
c -
Full cold mark
d -
Fluid reservoir
7876
Part No.
92-858074K01
90-8M0057081
MARCH 2011
eng