Service; Replacing The Firebricks; Replacing The Brick Retainer; Replacing The Door Glass - Dimplex Nectre n65 Installation/Operation Instruction Manual

Service

Always use a qualified technician or service agency to repair this unit.

Replacing the Firebricks

Over time the firebricks may become cracked and crumble away. If this happens they should be
replaced soon after.
To replace the firebricks:
1. Remove all ash.
2. Raise the brick retainer so that the bricks can be removed.
3. Replace with new bricks, refractory bricks in the
rear, and vermiculite bricks in the sides and base. Refit
brick retainer.

Replacing the Brick Retainer

Over time the original brick retainer may burn out, in which
case it can be replaced with a new one.
To replace the brick retainer:
1. Raise the old brick retainer and remove the firebricks.
Remove the old retainer.
2. Refit the firebricks and then fit the retainer over the top
locking them into position.

Replacing the Door Glass

This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench. When
replacing the glass, the glass gasket should also be replaced to make sure it is properly sealed.
To remove the door:
1. With the Allen key supplied, remove the top air control handle from the air slide.
2. Open the door 90°.
3. With one hand on top of the door and the other supporting it underneath, raise it on the hinge pin
until the top door hinge clears the top of the hinge pin.
4. Lower the door until the lower door hinge clears the bottom of the pin.
To replace the door glass:
1. The door glass is held in position by the rectangular glass retainer fixed by four M6 screws, two at
the top and two at the bottom.
2. Using the 4 mm Allen key supplied with the stove, remove the four screws and the glass retainer.
3. Remove the glass and the old door seal rope.
4. The new glass will have been supplied with a length of grey door seal with adhesive strip on one
side. Remove the wax paper backing from the adhesive and stick the door seal along the 5 mm
thick edge of the glass. With the forefinger and thumb fold the door seal over each side of the
glass. Do this around the external edge of the glass plate.
5. Refit the new glass with door seal into position in the door. Place the glass retainer over the top
and fasten with the four M6 screws.
NOTE: Take extra care not to over-tighten the screws, otherwise the glass will crack when the
!
stove gets hot and the door expands.
Figure 16
LH Brick
Retainer
Vermiculite Brick
RH Brick
Retainer
23