Do you have a question about the OAKHURST and is the answer not in the manual?
Questions and answers
martyn
March 30, 2025
why does my Dimplex keep cutting out and restarting?
1 comments:
Mr. Anderson
March 30, 2025
The Dimplex OAKHURST may keep cutting out and restarting due to a dirty air filter. If the filter is clogged, it can restrict airflow, causing the unit to overheat and shut down as a safety measure. Cleaning the air filter by rinsing it with water, drying it with a fabric towel, and ensuring the coarse black filter faces the front when reinstalling may resolve the issue.
Page 1
OAKHURST, AUBERRY OKT20, AUB20 EN : This product is only suitable for well insulated rooms or occasional use. DE : Dieses Produkt ist nur für gut isolierte Bereiche oder gelegentli- che Verwendung geeignet. FR : Ce produit convient uniquement à des endroits bien isolés ou pour un usage occasionnel. IT : Questo prodotto è...
Dimplex OPTIMYST Stove Introduction Thank you for choosing this Dimplex electric fire. Please read this information guide carefully to be able to safely install, use and maintain your product. Important Safety Advice When using electrical appliances, basic precautions should always be followed to reduce the risk...
Technical Information : Model No: OAK20, AUB20. 230V 240V Heat Output Nominal Heat Output Minimum Heat Output Maximum Continous Heat Output P max,c Auxiliary Electricity Consumption In Standby mode 0.45 0.48 with mechanic thermostat room temperature control. General Information Only use filtered water in this appliance. This model is designed to be free standing and is normally positioned near a wall.
pinched between the nozzle and the sump, place the cable in the slot in the wall of the sump. 8. Replace the Sump Nozzle and secure it by turning the two red tabs by 90 degrees (Fig 6) Filling the Water Tank 9.
6. Remove the defective lamp, by gently lifting vertically and disengaging the pins from the lamp holder, (See Fig.4 and 4a). Replace with a Dimplex OPTIMYST, 12V, 45W, Gu5.3 base, 8º beam angle, coloured lamp. (Purchased from our website http://spares.dimplex.co.uk) 7.
Should you require after sales information or assistance with this product please go to www.dimplex.co.uk and select “Customer Support” or ring our help desk on 0344 879 3588 (UK) or 01 842 4833 (R. O. I.). Spare parts are also available on the web site.
Brazil BR P10708894-9 India IN 4122/KOLNP/2008 New Zealand NZ 571900 Troubleshooting Symptom Cause Corrective Action The flame effect will Mains plug is not plugged in. Check plug is connected to wall socket not start. correctly. Low water level. Check that the water tank is full and there is water in the sump.
Page 12
OPTIMYST is a trade mark of Glen Dimplex Heating & Ventilation Dimplex. TEL: 0344 879 3588 MILLBROOK HOUSE WEBSITE: www.dimplex.co.uk GRANGE DRIVE HEDGE END Republic of Ireland Tel. 01 8424833 SOUTHAMPTON Glen Dimplex Heating & Ventilation. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in...
Need help?
Do you have a question about the OAKHURST and is the answer not in the manual?
Questions and answers
why does my Dimplex keep cutting out and restarting?
The Dimplex OAKHURST may keep cutting out and restarting due to a dirty air filter. If the filter is clogged, it can restrict airflow, causing the unit to overheat and shut down as a safety measure. Cleaning the air filter by rinsing it with water, drying it with a fabric towel, and ensuring the coarse black filter faces the front when reinstalling may resolve the issue.
This answer is automatically generated