Table of Contents
Advertisement
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Hardware Reset
ETHERNET
IO
1 2 3 4
RESET
P
Reset button
Status LED
There is a reset button on the back cover of the Network Camera. It is used to reboot the
Network Camera or restore the Network Camera to factory default. Sometimes rebooting the
Network Camera could set the Network Camera back to normal state. If the problems remain
after rebooted, restore the Network Camera to factory default and install again.
Reboot: Press and release the reset button. The status LED will blinks in red.
Restore: Press the reset button continuously until the status LED blinks in red and green
simultaneously. Note that all settings will be restored to factory default.
6 - User's Manual
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Network Camera IP7133/IP7134 and is the answer not in the manual?
Questions and answers
what is url for rtsp port streaming .
The RTSP URL for streaming on the Vivotek Network Camera IP7133/IP7134 is:
//
rtsp://
For example:
rtsp://192.168.5.129:554/live.sdp
- "192.168.5.129" is the IP address of the camera.
- "554" is the default RTSP port.
- "live.sdp" is the stream access name.
This answer is automatically generated