Using the Exercise Stress Option
1. Select the Begin button to start the pre-exercise phase. Selections will appear similar to those shown in
Figure 1-1.
At the start of an exercise stress test, the ELI 280 will take a few seconds to learn the QRS morphology
prior to display of the Start Exe and 12-lead ECG buttons.
The heart rate, NIBP less than 1-minute old, stage, exercise equipment status, ECG gain, ECG speed, ECG
filter, AM12 or WAM, and battery status are displayed in the top portion of each displayed phase.
NOTE: Equipment Error is displayed when no treadmill or ergometer is connected and this
equipment has been selected for the exam.
The PRE-EXE (pre-exercise) phase time (mm:ss) is displayed in the lower right corner of the display.
Figure 1 Pre-Exercise Phase Display
Start Exe:
Allows movement from Pre-exercise to the Exercise phase.
ECG:
Prints a 12-lead ECG according to configuration format settings labeled MANUAL PRINT.
NOTE: The Start Exe and ECG buttons will appear after QRS morphology is learned.
RHY:
Begins printing continuous ECG and the button will change to Stop to end printing.
USING THE ELI 280 EXERCISE STRESS OPTION
Page | 11