3.
To remove the wireless antenna cables and transceivers, release the wireless antenna cables from the
clips (1) built into the back of the display, and then remove the antenna cables and transceivers (2).
Antennas for non-touch models are available using spare part number 809271-001.
NOTE:
Number of antennas and transceivers may vary.
4.
To remove the display/webcam cable, disconnect the cable (1).
5.
Remove the cable from the clips built into the display panel (2), and then remove the cable from the
display (3).
6.
If replacing the display enclosure, be sure that the subcomponents (including the webcam/microphone
module, the antenna receivers, and all associated cables and hardware) are transferred to the new
enclosure.
Reverse this procedure to reassemble and install the display assembly.
Component replacement procedures
61