Using An Existing Field Boundary - Raven OmniSeed Viper Pro Calibration & Operation Manual

Using an Existing Field Boundary

On the Main tab, select the Information icon displayed below the Map area and touch within the field
1.
boundary displayed on the screen.
A preview of the selected job and field boundary area is displayed.
2.
Select the desired action to perform using the displayed field boundary.
3.
Touch 'Delete This Job' to delete the job shown in the preview area. The as-applied or coverage
a.
information associated with the selected boundary will be deleted. The field computer will prompt the
operator to save or discard the associated field boundary.
Touch 'View This Job' to view the coverage or as-applied data logged during the previous job
b.
associated with the selected field boundary.
Touch 'Open This Job' to open the selected job and resume product application using the previous
c.
coverage information.
Touch the 'Start New Job' button to begin a new job using the displayed in the preview.
d.
The Viper Pro will begin the job set up process for a new job. Refer to the Starting a Standard Job
section on page 95 for information on completing the job set up process. When the new job is ready to
begin, Viper will prompt the operator to select whether the previous job coverage information should
be saved or deleted.
Touch 'Cancel' to exit the job preview screen and return to the main screen.
e.
Manual No. 016-3001-015 Rev. C
Using the OmniSeed Viper Pro System
101