Table of Contents
Advertisement
Locate and mark the four 4.5 mm (3/16 inch) mounting holes.
1.
Locate and mark two 14.0 mm (0.551 inches) access holes (used for connecting the
2.
antenna barrel connector and the LED power and data cable to the unit. Notice that these
holes are located off-center toward the top of the unit.
Drill the four 4.5 mm (3/16 inch) mounting holes.
3.
Drill the two access holes (14.0 mm, 0.551 inch) holes using a 35/64 drill bit.
4.
Use the nuts that are supplied with the unit (in plastic bag).
5.
ID TECH VP5300M User Manual
Page | 15
Advertisement
Table of Contents
