Table of Contents
Advertisement
11
Setting up and assembly
11.1 Setting up
Place the components of the Alga-
NOTICE
emaster 10 onto a clean, solid and
even surface, ensuring they do not
slip.
Be careful not to damage the reac-
tor container.
Seal off all connections on the con-
troller which are not being used
with the protective caps.
Procedure
1.
Carefully unpack the device and accessory parts and check for
completeness.
11.2 Assembly of the attachments
11.2.1 Securing the vessel lid
To open/close the vessel lid, screw/unscrew the 4 screws located
on the outside of the vessel lid by hand.
Be careful not to damage the rim of the container.
11.2.2 Gas intake tube
Make sure there is a distance bet-
NOTICE
ween the stirrer and the correct
installation of the tube.
Push the gas intake tube into the tube fitting of a plug with grom-
met (Fig. 5, (26)) underneath the lid.
In order not to disturb the stirring process, the gas intake tube
must be positioned on the side or under the stirrer.
11.2.3 LED panels
The 4 connection sockets for the
NOTICE
LED panels (Fig. 3, (16)) can be as-
signed freely, as required.
1.
The 4 connection sockets for the LED panels (Fig. 3, (16)) can
be assigned freely, as required.
2.
Place the reactor container onto the base plate and install the
LED panels. Place it next to the controller and screw the vessel
lid onto the reactor container (see following chapter).
3.
Install the optional accessory parts, as required:
•
Gas intake tube
•
Temperature sensor
•
pH sensor
•
Hose pumps
•
Motor
4.
Connect the device to the power supply (Fig. 3, (19)) using
the supplied power cord and press the main power switch.
5.
The device is ready for operation.
2.
Screw the LED panels to the base plate.
The edge of the base plate has several drill holes (distance 15
degrees) for individual placement.
3.
Connect the LED panels to the connection sockets of the
controller (Fig. 3, (16)).
11
Advertisement
Table of Contents
