Maintenance; Changing The Lamp - Xerox DP1011 User Manual

Changing the Lamp

Xerox DP1011 User's Guide

Maintenance

The projector's lamp life is approximately 1500 hours of use. The
projector automatically monitors the lamp life. After 1500 hours of
use, the projector displays the message:
The Lamp has been in use for over 1500 hours. You should
purchase a spare bulb.
When you see this message, please contact your local reseller or
service center to change the lamp as soon as possible.
Warning—To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if dropped.
Warning—Lamp compartment is hot! Allow the projector to cool
down at least 30 minutes.
To change the lamp module
1. Turn off the projector's power by pressing the power button on
the Remote Control or Projector Panel.
2. Disconnect the power cord.
3. Use a screwdriver to remove the two screws from the cover.
Maintenance
21