Troubleshooting - Midea FP-90LTL065GETM-N2 Owner's Manual

MAINTENANCE

Troubleshooting

If the appliance does not start or it stops during the operation, initially try to
nd a solution to the problem based on the table below. Otherwise, contact
the service center.
Description
No washing
No water flows in
Abnormal draining If the end of the
Abnormal spin
Description
flashes/
blinks
flashes/
blinks
flashes/
blinks
flashes/
blinks
Note!
• After checking, try to use the appliance again. If the problem persists
or the display shows other alarm codes again, contact the service center.
If the power is o or the fuse is burned out.
If the water volume reache
not work if the water amount does not reach the required water level)
The power supply volteg is too low.
If the power is o or the fuse is burned out.
If the water supply is cut o or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the ltering screen of inlet valve is blocked by dirt.
If the coil of the inlet valve is damaged.
If the "Start / Hold" button is pressed after the power switch is pressed.
water drain hose is placed very
water drain hose is immersed in and blocked by a pool of water.
If the internal rubber ring of drain valve is blocked by dirt.
If the top lid is closed.
If most of the clothing are at one side of the drum or if too many
clothes are loaded in the machine.
If the washer is not placed in stable condition or it is placed
state. (The ground is not at).
Reason
Alarm for abnormal
water filling.
Alarm for lid not closed
before wash and spin.
Unbalanced wash load
during spinning
Alarm for water
unfinished water draining
Inspection Items
the required water level.(The washer will
Check the water tap is
opened or not.
Close the lid.
Evenly distribute the clothes in
the drum by hand.
Check the water level
sensor and drain pump .
10
19
high.If the end of
an inclined
Solution