Troubleshooting Guide - Midea MTW70 User Manual

TROUBLESHOOTING GUIDE

If the clothes washer does not perform as expected, malfunctions or an alarm is
sounding, please check the following list of possible solutions.
If a solution can not be found or the problem persists, please contact Midea service (refer
to page 15).
Do not, under any circumstance, dismantle the appliance yourself.
FAULT
No water is flowing in
Not washing
Not draining
Abnormal or not spinning
The following table is a list of the fault indicators and corresponding alarms.
DISPLAY
POSSIBLE SOLUTION
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
CAUSE
Alarm for abnormal
water intake.
Alarm for water drain
has not finished.
Alarm for lid not closed
before wash and spin.
Alarm for washing stay
at one side.
Check the power source is ON
Check if the circuit breaker has been triggered or fuse is not
burnt out
Check the water supply is in the open position and the water
pressure reaches the minimum required by the washer
Check the inlet hose has been installed correctly
Check the filter of the inlet valve is not blocked or obstructed
Check if the Start/Pause button has been pressed
Check the power is on and the circuit breaker has not been
tripped or the fuse burnt out
If the minimum water level is not reached
Check if delay start has been set
Check the drain hose is not too high
Check the drain hose is not obstructed
Check the drain pump is not obstructed
Check the lid is completely closed
Check that the laundry inside the drum has not accumulated
to one side
Check the laundry is evenly distributed
Check that the laundry does not exceed the rated capacity
Check the clothes washer is level
SOLUTION
Check the water tap is
opened or not.
Check the water level
sensor and drain pump.
Close the lid.
Manually balance clothes
in the barrel by hands.
14
Note:
To stop the alarm,
open the lid. Close the
lid once the issue has
been remedied and
resume the wash
program.
If problems persist,
contact Midea
customer care when
convenient.