Troubleshooting; Appendix - Midea MA500W210 Series User Manual

Troubleshooting

Check these solutions if your washer...
Error Codes
Error Code Error Symbol Possible Cause
The washer takes more than
30 minutes to fill with water.
After water finishes entering
your washer, the water level
has not changed in 5 minutes.
The unit takes more than 10
minutes to drain.
The lid is open.
The unit is out of balance in
spin operation.
Washer is not level.
Impact switch failed.
Load sensing failed
Water leveling sensor failed
Door lock failed
Dark Lighting
Blink
Solutions
Check if the lid is open.
Check as "No water or
not enough water"
Check for water leakage.
Check as "Does not
drain or spin"
Close the lid.
The door lock or PCB
is failed. Call service
center.
Check as "Vibrates
or is too noisy"
Call service center.
Adjust the washer level
refer to installation. If
situation continues, call
service center.
Call service center.
Call service center.
Call service center.
1.power off 30 seconds and
restart
2.Call service center.
25

Appendix

Fabric Care Chart
The following symbols provide garment care direction. The Clothing care
labels include symbols for washing, bleaching, drying and ironing, or dry
cleaning when necessary. The use of symbols ensures consistency
among garment manufacturers of domestic and imported items. Follow
care label directions to maximize garment life and reduce laundering
problems.
Wash Cycle Special Instructions
Normal Line Dry/ Hang to Dry
Permanent Press /
Wrinkle Resistant / Drip Dry
Wrinkle Control
GentleDelicates / Dry Flat
Hand Wash heat Setting
Water Temperature** High
Hot Medium
Warm Low
Cold Any Heat
bleach No Heat Air
Any Bleach when ( iron-Dry or Steam
needed ) Temperatures
Only Non Chlorine -
(color-safe)
High
Bleach when needed ( )
Tumble Dry Cycle Medium
normal Low
Permanent Press/
Wrinkle Resistant/
Wrinkle Control
Gentle Delicates /
** The dot symbols represent appropriate wash water temperatures for various items. The temperature range for
Hot is 105-125°F/41-52°C,for Warm 85-105°F/29-41°C and for cold 60-85°F/16-29°C.
(Wash water temperature must be a minimum of 60° /
The clothes washer can not ensure these temperatures because the actual temperature of the water entering
your washer depends on water heater settings and regional water supply temperatures. For example, cold
water entering the home in the northern states during winter may be 40°/F4°C which is too cold for effective
cleaning In this situation you will need to adjust the water temperature by selecting a warm setting, adding . ,
some hot water to the MAX FILL line, or using your Washer's heating option, if available.
Warning Symbols for
laundering
Do Not Wash
Do Not Wring
Do Not Bleach
Do Not Tumble Dry
No Steam (added to
iron)
Do Not Iron
Dryclean
Dry Clean
/ Do Not Dry Clean
Line Dry/ Hang to Dry
Drip Dry
Dry Flat
For machine-washable
wool Loads should be .
under 8 pounds.
F 16 C for detergent activation and effective cleaning °
26
.)