Panasonic KV-S1057C Service Manual page 56

Symptom
2. ON/OFF monitor circuit does not
function.
Scanning position is 1. After replacing or
shifted. re-assembling the CIS assembly
and/or mechanical parts related
to conveying documents,
re-adjustment of scanning
position has not been done.
2. The CIS assembly is not
installed properly.
The document 1. Document Guides are not set
skews when properly according to the size of
scanned documents on the Feed Tray.
2. Mixed Batch Card Guide is not
set properly.
3. ADF Door is not closed tightly.
4. Rollers are dirty.
5. Rollers are not properly installed
into their default positions when
re-assembling.
6. Rollers have reached their life
expectancy.
Possible Cause Check Point
1. Check the soldering condition of the following parts
and of their surrounding circuits on the PANEL Board.
For S1057C/S1027C
(1) SW4100, R4101
(2) SW4101, R4102
(3) SW4102, R4100
(4) SW4103, R4106
(5) SW4104, R4105
(6) SW4105, R4103
(7) SW4106, R4104
For SL1066/SL1056/SL1055/SL1036/SL1035
(1) SW5000, R5017
(2) SW5001, R5018
(3) SW5002, R5019
(4) SW5003, R5020
2. Check the following connection.
For S1057C/S1027C
(1) Between CN4000 (LCD PANEL Board) and
CN3 (CONTROL Board)
(2) FFC Cable
(3) Between CN4002 (LCD PANEL Board) and
CN4100 (SW PANEL Board)
For SL1066/SL1056/SL1055/SL1036/SL1035
(1) Between CN5000 (PANEL Board) and CN3
(CONTROL Board)
(2) FFC Cable
3. Check the soldering condition of the following parts
and their surrounding circuits on the CONTROL
Board.
(1) CN3
4. Check the following signals on the PANEL Board.
For S1057C/S1027C
(1) IC4000
For SL1066/SL1056/SL1055/SL1036/SL1035
(1) IC5000
5. Replace faulty parts or boards.
Perform the "All Position" and/or
1.
"Individual Position" in Sec.
scanning position can be adjusted properly.
1. Re-assemble the CIS Assembly. (See
(
Assembly Instructions P.23
1. Slide and set the Document Guides according to the
document size.
1. Set the guide properly.
1. Close the door until it clicks into place, after opening it.
1. Clean the rollers with the roller cleaning paper.
After cleaning the Paper Feed Roller and Double-feed
2.
Prevention Roller, perform the "Clear Counter (After
Clean Roller)" in the service utility to clear the
cleaning roller counter. (See
1. Check the roller attachments to the scanner (whether
a gap between roller and conveyor is secured
equally).
2. Re-attach the rollers to their default positions
1. After checking the configuration, replace the rollers.
2. After replacing the Paper Feed Roller and Double-feed
Prevention Roller, perform the "Clear Counter (After
Replace Roller)" in the service utility to clear the roller
replacement counter. (See
56
( ) so that the
Test P.47
Disassembly and
)
( )
Scanner Counter P.46
( )
Scanner Counter P.46
Remarks