Required Adjustments After Part Replacement - Panasonic KV-S1057C Service Manual

7.6.

Required Adjustments after Part Replacement

Note: *1
When All Position in Sec. Adjustment (P.50) is done, the setting values except for the values set for the Individual Position in
Sec. Adjustment (P.50) will be also changed.
Replaced circuit board assembly or part
IC4 (FLASH memory on CONTROL Board)
IC5 (EEPROM on CONTROL Board) or CONTROL
Board
Starting Sensor or STARTING SENSOR Board
Double Feed Detector [Generator] or ULTRASONIC
SENSOR (G) Board
CIS (F)
CIS (B)
Scanning Glass (F)
Scanning Glass (B)
Conveyor Roller
Exit Roller
Others (when assembling or disassembling parts which
will affect the scanning positions.)
Adjustment required
1. Adjust Shading.
1. Execute Sensor Sensitive Level in Sec.
( ).
P.50
2. Execute Double Feed in Sec.
adjust the double feed sensitivity.
3. Adjust Shading. (Only when replacing CONTROL
Board assembly.)
4. Adjust All Position.
5. Adjust Individual position manually, as required.
6. Set USB ID. (See.
Adjustment
7. In Sleep Mode, set the "Power Off" condition to "240
min". for KV-S1057C-U / S1027C-U / SL1056-U
1. Execute Sensor Sensitive Level in Sec.
( ) to adjust the Start Sensor's sensitivity.
P.50
2. Execute Double Feed in Sec.
adjust the double feed sensitivity. (Only when replac-
ing Starting Sensor)
3. Adjust All Position or the following positions:
a. Adjust Length in Individual Position.
b. Adjust Paper-end Position in Individual Position.
c. Adjust Front Vertical Position in Individual Position.
d. Adjust Back Vertical Position in Individual Position.
1. Execute Double Feed in Sec.
adjust the double feed sensitivity.
1. Adjust Shading.
2. Adjust All Position or Front Horizontal Position in
Individual Position.
1. Adjust Shading.
2. Adjust All Position or Back Horizontal Position in
Individual Position.
1. Adjust Shading.
1. Adjust Shading.
1. Adjust Length in Individual Position, or adjust All
Position.
1. Adjust Length in Individual Position, or adjust All
Position.
1. Adjust the following adjustment or All Position:
a. Adjust Front Vertical Position in Individual
Position.
b. Adjust Front Horizontal Position in Individual
Position.
c. Adjust Back Vertical Position in Individual
Position.
d. Adjust Back Horizontal Position in Individual
Position.
38
Adjustment
( ) to
Adjustment P.50
( ))
P.50
Adjustment
( ) to
Adjustment P.50
( ) to
Adjustment P.50
Remarks
*1
*1
*1
*1
*1
*1
*1