Vision Fitness X6000DA Assembly Manual page 5

ORANGE BAG
1
STEP
• Install the left and right stabilizers with
the four bolts (M8 x 16
Blue 5 Allen wrench.
MM
• Cover both stabilizers with the
included rubber covers.
• Insert the rear folding axle shaft into
the rear tube.
BLUE BAG
2
STEP
• Slide a wavy washer (M16) onto
the right-hand side of the rear folding
axle, followed by the right-hand pedal
arm guide rail (the guide rails each
have a blue indicator arrow printed
on their sides; these arrows should
face to the outside).
• Slide a flat washer (M16) onto the
right-hand side of the rear axle,
followed by a rear wheel.
• Slide the large flat washer
(M8) onto the right-hand side of the
rear axle, and secure with a bolt
(M8 x 16 ).
MM
• Repeat above steps to install left-
hand pedal arm guide rail.
• X6200HRT/DA only: Slide the toe-
piece onto the pedal arm while
simultaneously lifting the locking knob.
Lock the toe-piece into place at the
STEP or GLIDE position.
), using the
MM
5
1
STEP
X6200HRT/DA
Only
2
STEP