Section 4: Wiring; Honeywell Gas Control And Pilot - Montigo H34VO Series Installation & Maintenance Manual

Divine Outdoor Gas Fireplace

Section 4: Wiring

Installing The Remote Switch
The Divine Outdoor's gas valve, located behind the lower trim, may
be connected to a wall switch. The valve generates its own power on
a millivolt circuit. Use only low voltage wire, and DO NOT connect
any external power to it.
Refer to Figure 4 for wiring requirements.
Note: The switch location must not exceed 30' from the fireplace.
Page 8
Installation
Honeywell (Q3450)
Pilot Assembly
Gas Control
Connector
Divine Outdoor
Figure 4. Wiring for the
Pilot Adjsutment Screw
Inlet Pressure
Figure 4a. Standing Pilot Diagram
Pilot Electrical
Harness Connector
Honeywell Gas
Control (SV9501M)
Wall
Water tight
Switch
Electrical box
VO Honeywell gas control and pilot.
Manifold Pressure
Test Connection
Montigo Part No. #RPOVO must be encased in a water-tight
electrical box OR ensure the box is installed in a dry location and
avoid any moisture. If installed outdoors, ensure you also install a
Ground Fault Interrupt per local code.
Source 110V
Distribution
Panel
White
Black
Power
Generator
Wall Switch
WARNING!
XG0150 - 140707.2