Installing The H38Von Log Set - Montigo H34VO Series Installation & Maintenance Manual

Divine Outdoor Gas Fireplace
Installing the Log set:
The H38VON are supplied with a six ceramic fibre log logset. Unpack
the logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous Instructions.
Rear / Bottom Log
Log A
Pilot Assembly
Notch in Log
Fireplace Base
Figure 9a. Bottom Rear Log, (Log A).
Step 2. Place the bottom Rear log (Log A) as shown in figure 9a.
Log C
Fireplace Base
Figure 9b. Left front Log, (Log C) and Right front Log, (Log B).
Step 3. P lace the bottom Right log (Log B) and bottom Left Log, (Log
C) as shown in figure 9b.
Log D
Fireplace Base
Figure 9c. Top Left Log, (Log D).
Step 5. Place Front Left log (Log D) as shown in figure 9c.
Page 12
Installation
Air Inlets
Log B
Air Inlets
Air Inlets
Air Inlets
Fireplace Base
Figure 9e. Top Right Log, (Log E)..
Step 6. Place Front Right log (Log E) as shown in figure 9e.
Log F
Fireplace Base
Figure 9f. Front Left Log, (Log F).
Step 7. Place Front Left log (Log F) as shown in figure 9f. Set notch in
lower end of Log F against stile on Log Grate.
Figure 9g. Completed Logset.
NOTICE
If logs are not placed properly, excessive sooting will result.
Log E
XG0150 - 140707.2