Definition Of The Electrical Control Buttons; Function-Related Precautions - JUKI PS-800-8045 Instruction Manual

6-2-8. Definition of the electrical control buttons

OUT9 Lifting / lowering of the rotary counter knife / moving knife
OUT11 Starting the cutting operation of the rotary moving knife
OUT12 Lifting / lowering of the clamp foot of the rotary counter knife

6-2-9. Function-related precautions

1. Do not cut a graphic that has a corner R of which is less than 5 (radius is less than 5 mm)
2. When cutting a graphic that has no corner with an excessive R, it is possible to cut it without interrupting
the cutting operation at connection points provided that the angle is 135 ° or more. If the angle is less than
135 °, the connection points intersect with each other at the position that is 0.1 mm ahead of them (as
shown in the figure).
3. From the beginning to the end of cutting, cutting effect will be maximized by extending or shortening the
cutting lines according to the specific effect of cutting. (Extend or shorten the length of cutting lines when
cutting a graphic)
– 66 –