JUKI PS-800-8045 Instruction Manual page 46

Error code
E217 Work file is not found
E218 Waiting for the work data
E219 Electrical failure. Contact the manufacturer.
E220 Wrong upgrade file
E221 Error has occurred during upgrading of the
file type
E222 Not yet upgraded
E223 It is not an upgrade file made by the same
OEM
E224 Cannot be connected to the head board
E225 Connect to the main board
E226 The current file is not valid
E227 File transfer has failed
E228 Data out of range
E229 This adjustment angle is too large
E230 Reading of graphics
E231 Presser foot error
E232 U disk has not been detected
E233 File reading / writing error
E234 Graphics out of range or head offset
E235 This file is not a file to be processed
E236 Ferroelectric damage
E237 Set an administration password
E238 Edit is not supported
E239 Contact the manufacturer
E240 Communication fault 2
E241 At the time of fault
Error description
It is necessary to re-scan or change over the graphics file.
Queuing time for processing graphic data differs with the
size of graphic
Contact the manufacturer of the equipment
It is necessary to replace the upgrade file with the new
upgrade file.
It is necessary to select the correct type of upgrade file for
the file to be upgraded
Contact the manufacturer of the equipment
Contact the manufacturer of the equipment
Inspect the head board for poor contact of the head board
connection line and / or breakage of the desk head plate
If the mother board for the display or the electric cord has
broken though the screen line connection is neither poor
nor broken, check that replacement of the broken part is
necessary.
It is necessary to change the graphics file if the graphical
file has broken or the file is not intended to be used with
this system type.
If the mother board for the display or the electric cord has
broken though the screen line connection is neither poor
nor broken, check that replacement of the broken part is
necessary.
Check whether the current graphics file data is defective
exceeding the ignorable range.
Corrected graphic angle is too large.
Decrease the changed angle value.
Process the necessary graphic data. Then, wait for a while
before starting operation.
Check whether the presser foot motor is normal.
Re-insert the U disk or replace the U disk with a new one.
① Replace the graphics file with a different one.
② Re-insert the U disk or replace the U disk with a new
one.
① Reset the position of reference point.
② Reset the offset value of the head 2 or head 3.
③ Replace the small-width graphic with the normal-width
graphic.
Replace the graphics file with a different one.
Contact the manufacturer of the equipment
Firstly, set the administration password.
Command or file that is not required to be edited
Contact the manufacturer of the equipment
CAN communication error has occurred, or the mother-
board program is old one.
① Time has been modified illegally.
② Motherboard battery voltage is low.
– 43 –
Solution