JUKI PS-800-8045 Instruction Manual page 40

Classifi-
cation of No. Parameter name
parameters
Reset P649 Alarm in the case of a
setting resetting error
P782- Output IO setting after
resetting
P787
P788-
P793
Tempo- P40 Automatic thread trimming
during temporary stop
rary stop
setting
P41 Needle position during
temporary stop
P45 Temporary stop switch type Self lock / Nor-
P799 Presser foot is not lifted
during temporary stop
Statistics P49 Bobbin thread remaining
amount is cleared at the
settings
time of turning the power
ON
P50 Operation stops after the
bobbin thread has run out
P51 Bobbin thread counter
setting is enabled
P46 Bobbin thread counter is
cleared at the time of turn-
ing the power ON
P47 Operation continues after
the counter has reached
the set value
P48 Counter setting is enabled
P52 Working hours counter
P779 Bobbin thread count mode
P780 Adjustment value of the
surplus amount of bobbin
thread (mm)
Thread P54 Thread clamp position at
the beginning of sewing
clamp
setting
P236 Laser output IO
P693 Enabling automatically
changeable hook
Standard
Range
value
Yes/No No
OUT1 to OUT6 Not set
/ Not set
High level / low High level
level
Yes/No Yes
Upper stop Upper
position / Lower stop posi-
stop position tion
Self lock
mal
Yes/No No
Yes/No No
Yes/No Yes
Yes/No Yes
Yes/No Yes
Yes/No Yes
Yes/No Yes
Yes/No Yes
IN1 to IN4 / Default
default
0 to 600000 0
0 to 200 0
Yes/No No
Yes/No No
– 37 –
Meaning of parameter and comment
Setting of IO after returning to the origin
Whether automatic thread trimming is
performed at temporary stop
Needle bar position when temporary
stop
Soft type of temporary stop, self-lock-
ing and normal
"Normal" automatically bounces when
touched
Whether the remaining amount of
bobbin thread is reset to 0 (zero) when
turning the power ON
In the case of "Enable", the sewing
machine stops when the consumed
bobbin thread length has reached the
"entire length".
In the case of "Set", statistics automat-
ically indicate the consumed bobbin
thread length
Whether the sewing counter is reset to
0 (zero) when turning the power ON
Whether the operation is continued
after the sewing counter has reached
the set value
Whether the sewing counter is enabled
In the case of "Enable", the machining
time statistics function is enabled
Statics mode of the bobbin thread
amount
Adjustment of the bobbin thread re-
maining amount
Thread clamp position at the beginning
of sewing
Laser output