Wall mounting a Featurephone
Locate, drill and plug the two screw locations as shown. The holes should be deep enough to accept a 2.5 cm
screw. Screw in the two screws, leaving 3 or 4 mm protruding. Remove the plinth from the base of the
phone and locate the two keyhole slots on the base of the phone over the two screws. The plinth is not
used.
Locate the two mounting screws 158mm apart and slide
the Featurephone down onto them by aligning the screw head
retaining holes correctly
158mm
The handset retaining clip, located directly below the hookswitch, must be reversed so that the handset is
secure when the phone is wall mounted.
Page 43