Wall Mounting - BT Freestyle 1100 User Manual

Wall mounting

Wall mounting
To wall mount your Freestyle 1100
Before you start ensure that the telephone
is in easy reach of the power supply and a
telephone socket.
Ensure that the wall can support the weight
of the unit.
Spare parts for your Freestyle 1100 are available
from your BT shop or supplier, or you can contact
us on 0345 697146.
• Use the template opposite to mark the
positions of the screws.
• Insert the screws using the wall plugs
supplied if necessary, leaving a 5mm gap
between the the screw heads and the wall.
• Place the wall bracket (the thin end of the
wedge at the top) over the screw heads and
pull down as far as possible to secure.
• Ensure that the power supply and the
telephone lines are connected to the base
unit, then fit the lines into the channels on
the bottom of the base unit securing the
lines under the small tabs.
37
• Any spare length of mains and telephone
lead can be stored in the hollow portion of
the wall bracket, but they should not be
wound around each other.
• Fit the top end of the base unit over the
lugs at the top of the
wall bracket.
• Ensure that the lines are fitted into their
slots at the bottom of the wall bracket, clip
the base unit to the bottom of the wall
bracket.
Be careful not to trap the wire aerial between the
wall bracket and the base unit.