Wall Mounting - BT Freestyle 90 User Manual

Freestyle 90 +UG 29/9/99

Wall mounting

Your Freestyle 90 can be wall-
mounted by using the bracket
provided.
You can use the bracket as a
template to mark where the screws
should go into the wall.
Before you wall-mount your Freestyle
90, check that:
the wall can support the weight of
•
the base unit and handset;
the position you choose leaves
•
sufficient space so that the base unit
(which is larger than the bracket) is
clear of any obstruction on the wall,
such as a shelf or cupboard. Room
should be left so that the handset can
be placed on charge without
touching any obstructions.
• leave enough room for aerial to be
extended when wall mounted.
Spare parts for your Freestyle 90 are
available from your BT shop or
supplier, or you can contact us on
Lo-call 0845 7697146 between 9.00am
and 5.30pm Monday to Friday.
2:28 pm Page 33
Drill two holes for the screws and
•
insert the wall plugs provided (if
required).
Drive the screws into the wall,
•
leaving about 5mm free on which
to mount the bracket.
Hook the bracket over the screw
•
heads to check if it fits correctly,
then remove again.
Make sure that the power supply
•
and the telephone cables are
connected to the base unit, then
fit the cables into the channels on
the bottom of the base unit.
Clip the bracket onto the base
•
unit as shown on the next page.
Hook the bracket with the phone
•
attached over the screw heads.
WALL PLUG
WALL
Attach the bracket by
hooking it over the screws
protruding from the wall.
SCREW
28mm
33