Sony MSU-900 Operation Manual page 76

Clear
LED
Buzzer
Bright
Switch
72
3
Adjust the brightness with the three control knobs.
Switch: Brightness of the built-in LEDs of the control
buttons
Tally: Brightness of the built-in LEDs of the camera
number/tally indication window
Other LED: Brightness of the other LED indicators,
such as those of the camera select block and the
ACCESS indicator
The master brightness can be adjusted with the right-
most control knob (Master).
When the adjustment is completed
[Home]
Press to return to the MSU adjustment menu, and
[Exit]
press to exit this menu.
To adjust the LCD
You can adjust the brightness and contrast of the display of
the menu control block.
1
[MSU Adjusting]
Press
menu.
The MSU Adjustment menu appears.
2
Press and highlight
The lower half of the display becomes the LCD
adjustment display.
Clear
LED
Buzzer
Bright
LCD Bright/Contrast
Bright Contrast
50
3
Adjust the brightness and contrast with the left two
control knobs.
76
Initial Settings
Home
1
1
LCD Bright
/Contrast
LED Brightness
Tally Other LED Master
78 93 78
on the MSU Configuration
[LCD Bright/Contrast]
.
Home
1
1
LCD Bright
/Contrast
50
When the adjustment is completed
[Home]
Press to return to the MSU adjustment menu, and
[Exit]
press to exit this menu.
To set the screen saver
The screen saver can be activated to protect the menu
display when the MSU-900/950 is not operated for a
certain time.
The screen saver can be turned on and off as required, and
the time to activate it can be adjusted.
1
[MSU SW Set]
Press on the MSU Configuration
menu.
The MSU SW Setting display appears.
MSU SW Setting
PIX/WF PIX/WF
All Mode
Synchro
ON ON
Screen Saver
Wait
Time
5
ON
2
[ON]
Press and highlight
3
When the screen saver is turned on, set the wait time
(in units of minutes) until it activates by pressing f or
F.
When the adjustment is completed
[Exit]
Press to exit this menu.
To select the switch operation modes
You can specify whether to switch the outputs from the
PIX2 OUTPUT and WF2 OUTPUT connectors in
synchronization with RGB switching on the adjustment
display (PIX/WF Synchro setting), turn on/off All mode
(PIX/WF All Mode setting) and select the operation mode
of the monitor output select buttons (PIX/WF Control
Mode setting).
Note
These settings are enabled only in Engineer mode.
Exit
PIX/WF Control
Mode
Alter-
Direct
nate
to activate the screen saver.