Section 1 General Information; Safety Information; Use Of Hazard Information; Service And Repairs - Hach ORBISPHERE C1100 User Manual

Section 1
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the
right to make changes in this manual and the products it describes at any time, without notice or
obligation. Revised editions are found on the manufacturer's website..

1.1 Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this
product including, without limitation, direct, incidental and consequential damages, and
disclaims such damages to the full extent permitted under applicable law. The user is solely
responsible to identify critical application risks and install appropriate mechanisms to protect
processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to
the operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install
this equipment in any manner other than that specified in this manual.

1.1.1 Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in
death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in
death or serious injury.
Indicates a potentially or imminently hazardous situation that may result in minor or moderate
injury.
Indicates a situation which, if not avoided, may cause damage to the instrument. Information
that requires special emphasis.

1.1.2 Service and repairs

None of the sensor's components can be repaired by the user. Only personnel from Hach Lange
or its approved representative(s) is (are) authorized to attempt repairs to the sensor and only
components formally approved by the manufacturer should be used.
Any attempt at repairing the sensor in contravention of these principles could cause damage to
the sensor and corporal injury to the person carrying out the repair. It renders the warranty null
and void and could compromise the correct working of the sensor and the electrical integrity or
the CE compliance of the sensor.
If you have any problems with installation, or using the sensor please contact the company that
sold it to you. If this is not possible, or if the results of this approach are not satisfactory, please
contact the Customer Service department of Hach Lange.

1.1.3 Precautionary labels

Read all labels and tags attached to the instrument. Personal injury or damage to the instrument
could occur if not observed.
General Information
D A N G E R
WA R N I N G
C A U T I O N
N O T I C E
3