Installation
2. Pull/twist off the protection cap and put to
3. Hold the sensor with the membrane facing
4. If present, remove the cotton washer from
5. Rinse the sensor head under a tap for 15
6. Do not dry the center electrode area, as the
12
one side. Remove the Dacron
inside the cap and discard it.
down to avoid spilling any electrolyte, then
carefully unscrew the shipment cartridge.
Drain the old electrolyte into a sink and flush
away. Discard the shipment cartridge and
membrane.
the top of the anode and discard.
seconds, aiming the jet of water directly onto
the sensor head.
gap between cathode and guard should be
left filled with water.
®
mesh from