Hach ORBISPHERE C1100 User Manual page 16

Installation
13. Continue turning until the cartridge is
14. The empty container, the screw top and
Note: It is normal that some of the electrolyte will
overflow from the replacement cartridge and into the
plastic container.
15. Rinse the sensor under a tap for about 5
16. Drain the overflow electrolyte from the
17. Discard the used container.
18. Take a new Dacron
19. Place the mesh in the center of the
20. Lower the sensor onto the protection cap
14
attached to the sensor, and the sensor is
automatically released from the container.
packing component can be discarded.
seconds to remove any excess electrolyte,
then gently wipe with a soft tissue to ensure
all parts are completely dry.
container into a sink and flush away.
®
mesh patch from the
box of O-rings in the recharge kit.
protection cap. It is very important that the
mesh is in the center of the protection cap
and covering the entire grille.
making sure not to disturb the mesh.