Advertisement
Install back Hanger Supporter at the Hanger Plate and screw it fi rmly. (Refer to Page 6 step B-3)
4
4
重新安裝吊架支架於吊板並將之鎖緊。（請參閱第 6 頁步驟 B-3）
5
Join Connector A (from Motor Assembly) to Connector B (from Hanger Plate Assembly).
5
將連接器 A（從發動機組件）連接至連接器 B（從吊板組件）。
Check Point After Install / 安裝後的檢驗點
1. Ensure the position of Ball Joint Holder is pressing on the top of the Switch Cover as shown.
(If the Ceiling Fan unable to operate due to misalign of the Ball Joint Holder, adjust the Ball Joint
position until the holder is placed right on the top of the Switch Cover).
如圖所示，確定球形接頭固定點的位置壓在開關罩的頂端。
（若吊扇因為球形接頭固定點位移而無法操作，調整球形接頭的位置直至固定點位於開關罩的正頂端）。
2. Ensure the Hanger Supporter is screwed fi rmly to the Hanger Plate.
確定吊架支架已鎖緊至吊板。
3. The Safety Wire is securely fi xed to the Carl Bolt and screwed to the Shaft.
將保險線固定至卡爾螺栓並鎖至轉動軸。
Wiring Instruction / 配線指示
D)
Connect the wires to the house supply line according to diagram shown.
1
1
如圖所示將電線連接至家裏的電源線。
Please use splice if using Terminal for installation.
若使用端子進行安裝，請使用接頭。
Electrical wiring must be done by competent
personnel.
Can cause fi re, electrical shock, Ceiling Fan
drops and injuries.
電線配線工作必須由能勝任的人員進行。
可以導致火災、電擊、吊扇掉落及受傷。
M11SU(REVISION)_EN-CT.indd 9
M11SU(REVISION)_EN-CT.indd 9
Hanger Supporter /
吊架支架
Hanger Supporter Screws /
吊架支架螺絲
Connector A /
連接器 A
CAUTION
WARNING / 警告
AWAS
Concrete Ceiling / 混凝土天花板
"Click" /
喀噠
Connector B /
連接器 B
Concrete Ceiling / 混凝土天花板
Earth (Green/
Yellow) / 地線
（綠色/黃色）
Live (Brown) /
火線(棕色)
9
Check / 檢查
Neutral (Blue) /
零線（藍色）
12/14/2010 12:40:06 PM
12/14/2010 12:40:06 PM
Advertisement
