Advertisement
C)
Install Motor Assembly to Hanger Plate Assembly /
安裝發動機組件至吊板組件
1
Insert Ball Joint into the Hanger Plate
1
Assembly.
將球形接頭插入吊板組件。
2
Adjust the Ball Joint to insert the Hanger Guide Rib into its slot. Refer to
2
Make sure the Ball Joint Holder is placed onto the Switch Cover. Refer to
調整球形接頭以將吊架導向擋邊插入其狹槽。如下圖所指的
確定將球形接頭固定點放在開關罩上。如下圖所指的
Fix Ball Joint correctly to Hanger Plate Assembly.
Can cause product not operate if Switch Cover has not
been pressed down.
正確地將球形接頭安裝至吊板組件。
若沒壓下開關罩可導致產品無法操作。
Do not push Switch Cover with other object, except
using Ball Joint given.
Can cause fi re, explosion, short circuit and electrical
shock.
除了所提供的球形接頭，切勿使用其他物體推開關罩。
這可以導致火災、爆炸、短路和電擊。
3
Remove Hexa Nut, Spring Washer, and Plain Washer from hole no. 1 Carl Bolt. Pass Safety Wire through Safety Wire
3
Outlet. Fix Safety Wire to no. 1 Carl Bolt as shown. Tighten the removed Carl Bolt, Plain Washer, Spring Washer and
Hexa Nut.
將六角形螺帽、彈簧墊圈和普通墊圈從1號孔卡爾螺栓取出。 將安全線通過保險線出口。如圖所示，將保險線固定至 1
號卡爾螺栓。鎖緊之前拆下的卡爾螺栓、普通墊圈、彈簧墊圈和六角形螺帽。
CAUTION / 注意
Safety Wire must be fi xed correctly.
Can cause injury if Ceiling Fan drops.
保險線必須正確地安裝。
若吊扇掉落會導致受傷。
M11SU(REVISION)_EN-CT.indd 8
M11SU(REVISION)_EN-CT.indd 8
Hanger Plate
Assembly /
吊板組件
CAUTION / 注意
Plain washer /
普通墊圈
Spring Washer /
彈簧墊圈
Concrete Ceiling / 混凝土天花板
in the illustration below.
in the illustration below.
。
。
Ball Joint Slot /
球形接頭狹槽
< Top View - For Viewing Purpose Only > /
< 頂視圖 - 只供參考 >
Concrete Ceiling / 混凝土天花板
1
Carl Bolt /
卡爾螺栓
Safety Wire /
保險線
Hexa Nut /
Safety Wire Outlet /
六角形螺帽
保險線出口
8
Ball Joint /
球形接頭
Ball Joint Holder /
球形接頭固定點
Switch Cover /
開關罩
Hanger Guide Rib /
吊架導向擋邊
12/23/2010 11:40:12 AM
12/23/2010 11:40:12 AM
Advertisement
