Advertisement
Install Canopy to Motor Assembly / 安裝罩蓋至發動機組件
E)
Remove the Screws, and separate Canopy as shown.
1
1
如圖所示拆除螺絲並分開罩蓋。
2
Take the Canopy (2 pieces) and place towards Hanger Plate Assembly as shown. (Canopy fi xing direction follow to
2
diagram as shown below.)
取罩蓋（2 片）並如圖所示朝吊板組件放置。（請遵循下圖所示的罩蓋安裝方向。）
Make sure Canopy is installed above Hanger Plate Assembly and clipped until the "click" sound is heard.
確定罩蓋被安裝在吊板組件之上並夾住直至聽到"喀噠＂聲。
NOTE / 備註
Make sure Canopy installation follow as diagram shown. / 務必遵循圖示安裝罩蓋。
Can cause Canopy damage after screw fi xing. / 鎖上螺絲後會導致罩蓋損壞。
M11SU(REVISION)_EN-CT.indd 11
M11SU(REVISION)_EN-CT.indd 11
Canopy / 罩蓋
Screw /
螺絲
Remove the Screws / 拆開螺絲
< Top View - For Viewing Purpose Only > / < 頂視圖 - 只供參考 >
Concrete Ceiling / 混凝土天花板
Canopy / 罩蓋
Press / 按
Canopy / 罩蓋
Hanger Plate Assembly /
吊板組件
Concrete Ceiling / 混凝土天花板
11
Pull / 拉
Click /
喀噠
12/14/2010 12:40:07 PM
12/14/2010 12:40:07 PM
Advertisement
