Intellifire Touch ® Control System Setup; Fixed Glass Assembly; Install Decorative Front - Heat & Glo 6000CMOD-IFT Installation And Appliance Setup

Table of Contents

Advertisement

Figure 11.10 Proper Placement of Media
(Optional Clear Glass Media Shown)
F. IntelliFire Touch
Detailed instructions for electrical wiring and connec-
tions are provided in Section 8.
Determine if this appliance is equipped with a Module
Reset Switch. See Section 8. Verify this switch is in
the ON position.
Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operat-
ing Instructions for the IFT-ECM are provided in Sec-
tion 3.J of the Owner's Manual.
3 POSITION SWITCH
LED INDICATOR
Figure 11.11 IFT-ECM
If this appliance is being upgraded to an optional Intel-
liFire Touch Remote Control, and/or optional power vent,
fan, or light kit are added as new accessory upgrade(s)
to fireplace:
1. The RC400 remote will need to be paired to the ECM.
2. Follow the installation instructions provided with the
IntelliFire Touch remote and/or accessory kit(s).
54
Heat & Glo • 6000CMOD-IFT, 8000CMOD-IFT Installation Manual • 2509-980 Rev. L • 6/20
Control System Setup
®
TOP VIEW
G. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Replacing Fixed Glass Assembly
• Replace the glass assembly on the appliance. Pull out
and latch the four glass assembly latches into the groove
on the glass frame. See Figure 11.1.
H. Install Decorative Front
WARNING! Risk of Fire! Install ONLY decorative fronts
approved by Hearth & Home Technologies. Unapproved
decorative fronts could cause fireplace to overheat.
This fireplace has been supplied with an integral
barrier to prevent direct contact with the fixed glass
panel. DO NOT operate the fireplace with the barrier
removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative front.

Advertisement

Table of Contents
loading

This manual is also suitable for:

8000cmod-ift

Table of Contents