Intellifire™ Touch Control System Setup; Install Decorative Front/Surround - Heat & Glo ESCAPE-30LP-IFT Installation Manual

I. IntelliFire™ Touch Control System Setup
• Detailed instructions for electrical wiring and connec-
tions are provided in Section 8.
• Determine if this appliance is equipped with a Module
Reset Switch. See Section 8. Verify this switch is in
the ON position.
• Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operat-
ing Instructions for the IFT-ECM are provided in Sec-
tion 3.J of the Owner's Manual.
3 POSITION SWITCH
LED INDICATOR
Figure 11.9 IFT-ECM
This appliance is factory-equipped with an IntelliFire™
Touch remote control. The remote was paired to the fire-
place and tested at the factory. It does not need to be
paired again, unless an accessory kit will be added at
the time of installation. If no additional accessory will be
added, simply follow steps one through seven below.
1. If installed, remove batteries from remote.
2. Verify that the new appliance has power and secure
electrical connections.
3. Adjust the ECM selector switch to 'REMOTE' mode.
4. Switch the master reset switch to 'ON' (if equipped).
5. Wait to verify LED indicator on the ECM stops flash-
ing.
6. Install batteries in the RC400 remote.
7. The RC400 remote will automatically pair to the appli-
ance as pre-set at the factory.
Heat & Glo • ESCAPE-35-IFT, ESCAPE-30-IFT Installation Manual • 2550-980 Rev. B • 6/18
34
TOP VIEW
J. Install Decorative Front/Surround
A decorative front and surround is required to complete
this installation. Installation instructions are included with
the decorative front and surround. Consult your dealer
for a list of decorative front and surround options.
WARNING! Risk of Fire! Install ONLY fronts and sur-
rounds approved by Hearth & Home Technologies. Un-
approved fronts and surrounds could cause fireplace to
overheat.
This fireplace has been supplied with an integral
barrier to prevent direct contact with the fixed glass
panel. DO NOT operate the fireplace with the barrier
removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative front and surround.