ROBBE AMPLITUDE Instruction And User's Manual page 15

12
14
01
Instructions and User Manual
ARF PNP
The entire drive train can now be inserted behind the
bulkhead in the fuselage. Attach the motor with the M3x6
screws. Controller, battery and receiver can be fixed with
Velcro. The receiver finds its place in the rear fuselage part
and should be well padded installed.
ARF PNP
For later adjustment of the center of gravity, the battery
may vary in position. Only after accurately determining
the center of gravity do you make a mark on the battery
and the fuselage wall so that the center of gravity remains
reproducible.
ARF
Sand the surface in the servo housings with sand paper.
13
W I N G S
02
ARF PNP
Mount the airscrew center section with propeller blades
on the motor shaft. Pay attention to a firm but sensitive
tightening of the nut. This is an aluminum thread!
ARF
Remove (cut) the brackets from the servo housing. Then
shrink wrap the servo in shrink tubing, and sand the tu-
bing to guarantee a smooth surface. Plug in an extension
cable and guide it through the opening in the center of
the wing. Optionally, you can also install the wing servos
with our Robbe servo installation frames. These are then
easier to dismantle for maintenance purposes.
15