ROBBE AMPLITUDE Instruction And User's Manual page 13

01
02
01
Instructions and User Manual
T H E H O R I Z O N TA L S TA B I L I Z E R
ARF
Mark the center of the elevator on the bottom.
ARF
Milling a small slot 2mm eccentrically to accommodate
the rudder horn of about 10x1.8mm, starting about 6mm
from the edge to the sealing lip in the rudder blade. Be
careful not to damage the top side!
ARF
First, cut the opening for the elevator linkage.
03
F U S E L A G E
02
03
ARF
Grind the elevator horn on both sides and glue it with
thickened 24h epoxy resin or Uhu Endfest 300. The bore
points backwards, so you got a distance from the bore to
beginning of the elevator of 12mm!
ARF
Sand the surface in the elevator servo housing with sand
paper.
ARF
Remove (cut) the brackets from the servo housing. Then
shrink wrap the servo in shrink tubing, and sand the tu-
bing to guarantee a smooth surface. Plug in an extension
cable and lead it forward in the fuselage.
13