ROBBE AMPLITUDE Instruction And User's Manual page 14

04
05
06
07
14
Instructions and User Manual
ARF
Now mount a shortened servo arm with a bore distance of
5-6mm in 90 ° position on the servo. Make sure the servo
is in the neutral position before doing so.
ARF
Make a linkage with Z-bend and 90 ° angle. The shaft di-
stance is 115mm. Make sure that the linkages are rotated
90 ° to each other!
ARF
Now thread the linkage suspended in the servo into the
fuselage and out through the outlet. Connect the servo
wire to the extension and pull it into the front of the
fuselage.
ARF
Glue the servo with thickened 24h epoxy and fix it rough-
ly.
F U S E L A G E
08
09
10
11
ARF PNP
Hook the elevator horn into the linkage and mount the
elevator to the fuselage with the M3 countersunk screws.
ARF
Due to the fastened neutral position elevator and the
servo horn in 90 ° position, the final position of the servo
is now automatically obtained. The servo axis should be
90 ° to the linkage. Also make an adhesive connection
from the servo to the fuselage opening. This increases the
stability greatly. Wait until the resin has fully cured.
ARF PNP
Solder the esc with the cables of the motor as shown in
the picture. If your controller does not have a programma-
ble direction reversal, please check the direction of rotati-
on in advance and change it if necessary by replacing two
cables!
ARF PNP
Insulate the solder joints with shrink tubing and fix the
cables to the motor using a cable tie.