Water Hose Removal; Anode Replacement; Trim Sender Removal - Volvo Penta SX-A Workshop Manual

Water Hose Removal

Anode Replacement

Trim Sender Removal

Publ. 7746477 English 06-2008
Once the water inlet nipple is removed, pull the water hose
4.
through the port toward the rear of the transom shield.
NOTICE! The sacrificial anode need not be removed unless it is
2/3 deteriorated and needs to be replaced.
Remove two screws, lock washers, flat washers, and anode.
1.
Clean mounting surface, then install new anode and attaching
2.
hardware. Tighten screws to 24 ± 4 Nm (18 ± 3 ft. lb).
Disconnect trim sender connector at wiring harness on engine.
1.
Record position of sending unit wires before removing. Use socket
removal tool 3854350 to push terminals out of rubber plug.
NOTICE! The use of alcohol or equivalent will make socket
installation into rubber plug easier.
Use a small straight tip screwdriver and pry the weatherpak
2.
retaining clip from locking tabs on the connector.
Transom Shield Assembly
183