Transom Shield Assembly
Gimbal Ring Installation
180
Push the exhaust bellows onto exhaust tube until it engages
9.
groove. Slide ground strap clip under hose clamp and tighten
clamp securely.
NOTICE! The exhaust bellows does not have a specific position.
Mounting the worm screw on top allows access
through an opening in the pivot housing.
Install the gimbal ring and pivot housing assembly to the steering
1.
shaft and align the lower steering pivot.
Install the gimbal ring to steering shaft screws and torque to 85 ±
2.
15 Nm (62 ± 11 ft. lb).
NOTICE! If reusing existing screws, apply Loctite 241 before
installation.
Publ. 7746477
English
06-2008