English
6.3
State of Charge
1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.4
LEDs on Battery
The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 19.
Malfunction in trimmer or battery.
6.5
LED on Charger
The LED indicates the operating status of the charger.
If the LED glows green, the battery is being charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7 Assembling the Trimmer
7.1
Mounting the Deflector
► Switch off the trimmer and remove the battery.
46
80-100%
60-80%
40-60%
20-40%
0-20%
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2
7.2.1
► Switch off the trimmer and remove the battery.
► Fit the fanwheel (2) on the shaft (3) with fan blades facing
down.
If the fanwheel is not fitted, the motor will not be cooled
properly and the trimmer will cut out during operation.
► Hold fanwheel (2) steady with one hand.
1
2
Mounting and Removing the Mowing Head
Mounting the Mowing Head
1
2
3
7 Assembling the Trimmer
3
2
1
2
0458-806-9621-A