Charging The Battery, Leds; Charging The Battery; State Of Charge; Leds On Battery - Stihl HLA 56 Instruction Manual

6 Charging the Battery, LEDs

► Check the controls, @ 10.1.
► If 3 LEDs on the battery flash red while you are checking
the controls: Remove the battery and contact your
STIHL dealer for assistance.
There is a malfunction in the hedge trimmer.
► If you cannot carry out these steps: Do not use the hedge
trimmer and contact your STIHL dealer for assistance.
6 Charging the Battery, LEDs
6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
0458-816-9621-A
6.3
The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
There is a malfunction in hedge trimmer or battery.

7 Assembling the Hedge Trimmer

7.1
► Remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
1
80-100%
60-80%
40-60%
20-40%
► Line up the coupling sleeve (1) and cutter bar (2) so that
the groove (3) and lug (4) face upwards.
0-20%
► Push the cutter bar (2) into the coupling sleeve (1).
► Turn the wing screw (5) clockwise and tighten it down
firmly.
7.2
► Switch off the hedge trimmer and remove the battery.

LEDs on Battery

Mounting the Cutter Bar

2

Mounting the Loop Handle

English
3
4
5
41