Table of Contents
Advertisement
Item
FC Controller Revision
ROM Revision
RISC Revision
Firmware Revision
Number of Connected Devices
Item
Firmware Option
Maximum Frame Length
Max IOCB Resource Allocation
Execution Throttle
Retry Delay
Retry Count
Port Name
Hard/Previous Address
Login Timeout
Node Name
Request Q Length
Response Q Length
Async Event Button
To display logs
To display logs for a Fibre Channel Interface Board,
click the LOG button (see also "4-1-3 Viewing Logs"
on page 4-9).
Port Information
Description
Fibre channel controller revision number
Fibre channel controller ROM revision number
Fibre channel controller RISC code revision number
Fibre channel controller firmware revision number
Number of devices recognized by the fibre channel controller
Setting
Description
Fibre channel controller operation parameters
Maximum Fibre Channel Interface data frame length
Maximum number of buffers for I/O request block
The maximum number of commands that can be sent to 1 target. When the maximum
number of commands have accumulated in the target's queue, do not send until the
queue empties.
The delay for each login retry on a target. The delay unit per retry is 100 msec.
The number of retries when login on a target failed
The port name of the fibre channel controller port (same as the node name)
The loop ID assigned to the fibre channel controller
The timeout value when the fibre channel controller logs in on a target (unit: seconds).
If set to 4 seconds or less, the default value of 4 seconds is set.
Fibre channel controller node name (same as the port name)
Size of fibre channel controller request queue (number of command entries)
Size of fibre channel controller response queue (number of response entries)
On when asynchronous events are enabled for the port, off otherwise.
4-3
Chapter 4 Maintenance
Advertisement
Table of Contents
Troubleshooting
