Table of Contents
Advertisement
3-5-2 DMW-S01NL/S02NL
A 2Gb fibre channel interface board (LSI44929o) is
installed in the DMW-S01NL/S02NL. To create and
delete logical drives, use the Windows Disk
Management Tool.
Creating Logical Drives
Proceed as follows.
1
Start the Disk Management tool by doing the
following.
Select Start > Settings > Control Panel >
Management Tools > Computer Management, then
click the Disk Management folder.
The Computer Management window opens.
2
In the Computer Management window, check to be
sure that all of the disks in the ST001 are set to
Dynamic/Online.
Note
If a disk is not set to Dynamic/Online, refer to the
explanations in the following sections and change
it to Dynamic/Online.
• "To change a Basic/Online disk to a Dynamic/
Online disk" (page 3-24)
• "To change a Dynamic/Foreign disk to a
Dynamic/Online disk" (page 3-25)
3
Create a volume as follows.
Right click the first disk (in this example, Disk 1)
in the volume and select Create Volume...
The Create Volume Wizard starts.
4
Click Next.
The next screen appears.
5
Select "Striped volume" and click Next.
The next screen appears.
3-23
Chapter 3 Preparations
Advertisement
Table of Contents
Troubleshooting
