Assembly; Reference To Chapter Safety Instructions; Loss Of Conformity With European Directives; Preparing For Installation - Siemens SIMOTICCS A 1FU9 Operating Instructions Manual

Assembly

5.1

Reference to chapter Safety instructions

Observe the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page 11).
• Comply with the applicable national and sector-specific regulations.
• When using the machine within the European Union, comply with the specifications laid
down in EN 50110‑1 regarding safe operation of electrical equipment.
5.2

Loss of conformity with European directives

Loss of conformity with European directives
In the delivery state, the machine corresponds to the requirements of the European directives.
Unauthorized changes or modifications to the machine lead to the loss of conformity with
European Directives and the loss of the associated warranty.
5.3

Preparing for installation

5.3.1

Requirements for installation

The following requirements must be satisfied prior to starting installation work:
• Staff have access to the operating and installation instructions.
• The machine is unpacked and ready for mounting at the installation location.
• Measure the insulation resistance of the winding before starting any installation work. If the
insulation resistance lies below the specified value, take appropriate remedial measures.
These remedial measures may necessitate the machine being removed again and
transported.
5.3.2

Safety instructions

Note
Note also the technical data on the rating plates on the motor enclosure.
1FU9
Operating Instructions, 07/2020, A5E46712792A
5
41