Troubleshooting - Sunny Health & Fitness SF-T7632 User Manual

PROBLEM
Treadmill will not start.
Running belt not centered.
Console not working.
E01 or E13: Message
failure.
E02: Burst
protection.
E03: No speed sensor
signal.
E05: Current overload
protection (Self Protecting
System).

TROUBLESHOOTING

POSSIBLE CAUSE
Not plugged in.
Safety Key (No. C27) is
not inserted.
Running belt tension is not
correct on the left or right
sides of the running board.
Wires from the console and
bottom control board are
not properly connected.
Transformer is damaged.
Wires from the console and
bottom control board not
properly connected.
Incoming voltage is lower
clash than 50% of the required
voltage.
Speed sensor
cannot be received by the
control board.
The incoming voltage is too
low or too high. The control
board is damaged.
A moving part
treadmill is
therefore the
unable to rotate properly.
SUGGESTED ACTION
Plug power cord into outlet.
Insert Safety Key (No. C27).
Tighten the left and right
adjusting bolts of the rear
roller.
Check wire connections from
the console to the bottom
control board.
If
damaged, contact customer
service.
Check wire connections from
the console to the bottom
control board. If the wire has
been punctured or damaged,
you will need to replace it. If
the problem is not rectified,
you may need to replace the
bottom control board.
Check that the incoming
power supply is the correct
voltage.
Check that the sensor wire is
properly
signal
damaged,
Check to see if the magnetic
sensor is damaged, replace
if necessary.
Restart the treadmill. Check
the
ensure its correct. Check the
control board,
damaged.
Inspect moving parts of the
treadmill to ensure that they
of the
are
stuck and
Check the motor, listen for
motor is
strange noise, and check for
a burning smell. Replace the
motor if necessary.
22
the transformer
connected.
replace wire.
incoming voltage
replace
operating correctly.
is
If
to
if