Table of Contents
Advertisement
Chapter 3: Procedures
Adjustment Procedure for End of Bar
This procedure is used to set the end of bar and obtain the shortest remnant length.
Procedure
Conditions:
•
Main bar feed power on
•
Air pressure set at 6 bar
•
No bar stock in the guiding channel
•
Bar feed in STOP mode
Step 1:
Press the MENU key on the display.
Step 2:
Press F4 (PAGE DOWN) until the PARAMETERS RELATED TO POSITIONING screen is displayed and press F3
(ENTER).
Step 3:
On the first screen displayed, END OF BAR POSITION, press F3 (SET).
HYDROBAR SPRINT 555
3 - 5
Advertisement
Table of Contents
Need help?
Do you have a question about the HYDROBAR SPRINT 555 and is the answer not in the manual?