A053 - Lathe Did Not Resume Its Production Cycle - LNS HYDROBAR SPRINT 555 Troubleshooting And Spare Parts Manual

1 - 2 6

A053 - Lathe Did Not Resume Its Production Cycle

LATHE DID NOT
RESUME ITS
PRODUCTION CYCLE!
POSSIBLE CAUSES:
-LATHE CLAMPING
DEVICE NOT CLOSED
-CLAMPING SIGNAL
MISSING (INTERFACE,
PLC INPUT A1)
Description:
The Safety Time For Part Feed Out Elapsed alarm occurs if the value set in INPUT OVERALL PART LENGTH is not reached within 1
minute after the bar feed is commanded to feed out.
Solution:
Alarm needs to be cleared. Press the STOP key on the remote control station to clear the message and reset the alarm.
•
Make sure that value for the INPUT OVERALL PART LENGTH is correct.
•
Check for any mechanical obstruction that will not allow the bar feed to reach the feed out distance.
Contact LNS America, Inc. for further information.
HYDROBAR SPRINT 555
A053
Chapter 1: Alarms